- Joined
- Oct 1, 2015
- Messages
- 1
- Reaction score
- 0
I have an outdoor compressor unit that has both a run capacitor and a start capacitor to run the motor. I have repaired several wires that were damaged by rodents. There is a black wire (with no markings) that goes from the start capacitor to area of the contactor but the spade connector was pulled off in the area of the contactor. There are a number of places where the spade connector could connect but I want to be sure I get it right. Can anyone tell me where on the contactor I should connect this wire? It is a 16 ga. wire.